P1040 BMW Fault Code

Description:

The Throttle Position sensor signals the Engine Control Module as to the current position of the engine throttle valve.
The current throttle valve opening is based on the driver's input from the gas pedal.

The ECM uses the information from this sensor to help calculate fuel delivery and spark timing.

P1040 Code Symptoms :

The scent may P1040 signal oil or coolant leaking from their normally closed-loop systems, or it may indicate dangerous exhaust gases invading your car's interior. Car and truck exhaust contains toxic gases such P1040, so if the inside of your car as if you were standing behind your car, get out and get it fixed.
Fight the urge to take a little nap first. So sleepy. That's the carbon monoxide talking, friends. At least open a window on your way to the shop.

Diagnosis And Repairing P1040

Parts or components should not be replaced with reference to only a P1040 DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.

How to fix P1040 code ?

• Faulty Air Flow Meter
• Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
• Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
• Faulty Variable Camshaft Timing (VCT) position solenoid

A good starting point in your diagnosis is checking all system fuses and fusible links. This can be done using the BMW DVOM on the voltage setting. You will want to test the fuses with circuits loaded.

Some fuses will appear normal until a load is placed on their respective circuit; at which point they will fail. This has been the cause of many 'phantom malfunctions'. Consult your vehicle information source for fuse and fusible link locations. If all fuses are in working order, you may want to check TCM relay operation by swapping identical relays. Usually the horn relay, starter relay, fuel pump relay, air conditioning clutch relay, and controller relays are similar enough in design to swap for diagnostic purposes.